CSBuild targets
Posted: Mon Aug 19, 2013 4:13 pm
CSBuild shows links from a selected actuator to target(s).
Can it show reverse links, from a selected target to actuator(s) ?
I think, at some time, I had it working in this mode, but could not do it again.
Did I dream ?
Is this feature implemented ?
Edited
I found the answer.
This mode choice is in the menu View/Target Lines.
Default is Target Lines=unchecked, then red lines show links from a selected actuator to target(s).
With Target Lines=checked, then blue lines show reverse links from a selected target to actuator's).
Can it show reverse links, from a selected target to actuator(s) ?
I think, at some time, I had it working in this mode, but could not do it again.
Did I dream ?
Is this feature implemented ?
Edited
I found the answer.This mode choice is in the menu View/Target Lines.
Default is Target Lines=unchecked, then red lines show links from a selected actuator to target(s).
With Target Lines=checked, then blue lines show reverse links from a selected target to actuator's).