graphics of pressure pads (DM/DMute)

[Zyx]

Is there a way to change the predetermined graphics of the pressure pads? Beowuuf?

BTW, here's an old list of the graphics (maybe not 100% accurate):


Level 0 Level 1 Level 2 Level 3
1=slime 1=slime 1=large plate 1=square gratting
2=puddle 2=puddle 2=not working 2=slime
3=crack 3=large plate 3=large plate 3=crack
4=large plate 4=large plate 4=large plate 4=small plate
5=large plate 5=large plate 5=large plate 5=large plate
6=not working 6=not working 6=not working 6=not working

Level 4 Level 5 Level 6 Level 7
1=slime 1=large plate 1=Slime 1=round gratting
2=puddle 2=hexagonal plate 2=Crack 2=slime
3=crack 3=small plate 3=not working 3=puddle
4=large plate 4=large plate 4=not working 4=hexagonal plate
5=large plate 5=large plate 5=not working 5=not working
6=not working 6=not working 6=not working 6=not working

Level 8 Level 9 Level 10 Level 11
1=square gratting 1=round gratting 1=not working 1=not working
2=slime 2=Crack 2=not working 2=hexagonal plate
3=small plate 3=not working 3=not working 3=not working
4=not working 4=not working 4=not working 4=not working
5=not working 5=not working 5=not working 5=not working
6=not working 6=not working 6=not working 6=not working

Level 12 Level 13
1=fire pad 1=not working
2=not working 2=not working
3=not working 3=not working
4=not working 4=not working
5=not working 5=not working
6=not working 6=not working


Note: the sixth graphic doesn't seem to exist!

[beowuuf]

Lol, I don't know, sorry...you'd think the floor graphics would be the same as the wall graphics, and whatever trick George used to swap references per level could be used to swap floor pads too...though within the limits (so you'd have to be careful not to create floor plates in place of a puddle, as they would likely spring up as decorations) George?