what wants to tell Sharp Resistance???

General messages about RTC and it's development.

Moderator: George Gilbert

Forum rules
Please read the Forum rules and policies before posting.
Post Reply
User avatar
RAF68
Lo Master
Posts: 408
Joined: Fri Jul 10, 2009 6:13 pm
Location: FRENCH
Contact:

what wants to tell Sharp Resistance???

Post by RAF68 »

what wants to tell Sharp Resistance???
User avatar
zoom
Grand Master
Posts: 1819
Joined: Tue Sep 23, 2003 1:27 am
Location: far away but close enough

Re: what wants to tell Sharp Resistance???

Post by zoom »

I cannot say what RTC does, but normally it is this:

Armor has 2 Values:

first value is Armor Value.
this is how good the armor protects.

second value, it is sharp resistance!
This ranges from 1 to 7, higher is better. How strong the armor material is.

When monster attack that have no sharp attack, you simply use the armor Value for defense.

when you have a monster (e.g. worm, dragon) that has a sharp attack, armor value probably gets less efficient.
This is calculated by how high the armor´s sharp resistance is and how sharp the attack is(1-7).

normally the armor value is reduced very much if the sharp resistance is low and the monster has a high sharp attack.
This makes a normally high armor value of 100 go down to effectively only 40 maybe!

If the monster has a lower sharp attack than the sharp resistance of the armor, armor value gets not reduced!
(mithril mail has a super high sharp resistance of (6 or 7); it has medium armor value of 70 compared to armor value of plate of darc with 180. Against certain (sharp attack-) monsters mithril becomes even better than the reduced plate of darc!)


if you want to read all about it look at the encyclopedia csb .
Post Reply