[Done for V0.39] Moving tables

Chaos Awakes · Post by **Chaos Awakes** » Mon May 22, 2006 2:28 pm

In DM2, you could pull and push tables about. I had assumed that tables in RTC would exhibit the same thing but try as I might I can't do it.
Am I doing something wrong, or is it not possible?

If so, a pull or push action would be useful.

Especially as that would allow the DM2 pull and push spells to be realised.

beowuuf · Post by **beowuuf** » Mon May 22, 2006 2:35 pm

If would be doable if you could click on tables.

Pushable monsters would also be doable if you could click on monsters!

Basically, a 'clickable' flag in general would be nice : )

George Gilbert · Post by **George Gilbert** » Mon May 22, 2006 2:35 pm

No, pushing / pulling aren't inherrent properties of tables.

You could probably get some kind of similar behaviour to DM2 by using the new move actions though.

beowuuf · Post by **beowuuf** » Mon May 22, 2006 2:41 pm

Yes, you could easily, providing you could click on tabels and have that generate an action. Then all the rest is doable by the designer - for pushing only, a move, for pushing or pulling a menu action saying push and pull and and of course pulling would move the party backwards too : )

George Gilbert · Post by **George Gilbert** » Fri Jun 09, 2006 3:03 pm

beowuuf wrote:Yes, you could easily, providing you could click on tabels and have that generate an action. Then all the rest is doable by the designer - for pushing only, a move, for pushing or pulling a menu action saying push and pull and and of course pulling would move the party backwards too : )

This can now all be done in V0.39 (and I've included an example of a push/pullable table in the example dungeons).