Page 1 of 1
[Done for V0.39] Moving tables
Posted: Mon May 22, 2006 2:28 pm
by Chaos Awakes
In DM2, you could pull and push tables about. I had assumed that tables in RTC would exhibit the same thing but try as I might I can't do it.
Am I doing something wrong, or is it not possible?
If so, a pull or push action would be useful.
Especially as that would allow the DM2 pull and push spells to be realised.
Posted: Mon May 22, 2006 2:35 pm
by beowuuf
If would be doable if you could click on tables.
Pushable monsters would also be doable if you could click on monsters!
Basically, a 'clickable' flag in general would be nice : )
Posted: Mon May 22, 2006 2:35 pm
by George Gilbert
No, pushing / pulling aren't inherrent properties of tables.
You could probably get some kind of similar behaviour to DM2 by using the new move actions though.
Posted: Mon May 22, 2006 2:41 pm
by beowuuf
Yes, you could easily, providing you could click on tabels and have that generate an action. Then all the rest is doable by the designer - for pushing only, a move, for pushing or pulling a menu action saying push and pull and and of course pulling would move the party backwards too : )
Posted: Fri Jun 09, 2006 3:03 pm
by George Gilbert
beowuuf wrote:Yes, you could easily, providing you could click on tabels and have that generate an action. Then all the rest is doable by the designer - for pushing only, a move, for pushing or pulling a menu action saying push and pull and and of course pulling would move the party backwards too : )
This can now all be done in V0.39 (and I've included an example of a push/pullable table in the example dungeons).